10 actions in 6 pieces of software · ranked by words, meaning and measured trust · 647 ms

1. 1openocd-jtagverified and signedpassport

   skillmohitmishra786/low-level-dev-skillsrecord

   • openocd-jtag

     OpenOCD skill for embedded hardware debugging. Use when configuring OpenOCD for JTAG or SWD targets, flashing firmware, connecting GDB to bare-metal targets, setting hardware watchpoints, or using J-Link with OpenOCD. Activates on queries about OpenOCD, JTAG, SWD, GDB remote target, flash programmin

2. 2openocdverified and signedpassport

   skillzhinkgit/embeddedskillsrecord

   • openocd

     OpenOCD 下载与调试工具，用于探针探测、固件烧录、Flash 擦除、GDB Server 启动、目标复位控制、 Telnet 在线调试（halt/resume/step/寄存器/内存/断点）、GDB 源码级调试，以及 Semihosting/ITM 输出捕获和底层查询。 当用户提到 OpenOCD、ST-Link、CMSIS-DAP、DAPLink、FTDI、烧录固件、擦除 Flash、GDB Server、 reset、interface/target/board 配置、openocd.cfg、在线调试、单步、断点、寄存器查看、 内存读写、semihosting 时自动触发，也兼容 /

3. 3flash-openocdverified and signedpassport

   skillleokemp223/embed-ai-toolrecord

   • flash-openocd

     当需要使用已探测或显式指定的产物与探针配置，调用自带脚本通过 OpenOCD 烧录嵌入式固件时使用。

4. 4debug-gdb-openocdverified and signedpassport

   skillleokemp223/embed-ai-toolrecord

   • debug-gdb-openocd

     当需要通过 OpenOCD 启动或附着 GDB 会话，调用自带脚本完成固件下载、在线调试或崩溃现场检查时使用。

5. 5io.github.microhenrio/openocd-mcpfound in code, not yet checkedno passport yet

   MCP servermicrohenrio/openocd-mcp

   • remove_breakpoint

     Remove the breakpoint at the given address.

   • list_breakpoints

     List all currently set breakpoints and watchpoints.

   • remove_watchpoint

     Remove the watchpoint at the given address.

   • connect

     Connect to OpenOCD. Call this first.

6. 6openocd-mcpfound in code, not yet checkedno passport yet

   MCP serverluiox/openocd-mcp

   • debug_attach

     Attach to a running target without resetting or downloading firmware. Uses launch.json config with request=

   • flash_download

     Flash firmware once using specified launch configuration without starting debug session.